I’m excited for these 1W nodes. I’m in an area outside a large city. The city has a lot of activity and I can hear much of it due to a station g2 on a sky scraper. But they can’t hear me. I think a little more transmit power in my area can bridge the divide and really extend the mesh
I have mixed feelings about these 1W modules. They must be handy in small setups with compact antennas, however, building the mesh despite the strict limits and TX power is half the fun. When it turns into a screaming match, there is no way back.
Btw. what is the second antenna connector for?
In the GTA (Canada) we have a shit ton of nodes but due to the environment it’s very hard to get far before you run out of hops. This node allows many nodes in a 15km radius to talk to each other or bounce to downtown with 1 hop. It’s elevated on a balcony. Also this module has much more sensitive receive stage so the increase in signal strenght is similar in both rx and tx.
The second connector is an unused SMA. That said I was planning to do a 2-node setup with low and high gain antennas, on the opposite ends of the box. 🤭 Fortunately this 5dBi antenna performs well enough for near nodes to not need a low gain supplementation.
GTA (Canada)
For those outside the trannasphere, this is the Greater Toronto Area, a bunch of towns clustered in the center-east of the country. Think of it like greater London or the cluster near Hong Kong.
Is that meant to be mounted… inside a wall?
Inside? No. It’s an enclosure for mounting outaide. There are various adapters, bolt to a wall, clamp on a pole, magnets, zip tie to something. The lid of the box is not installed.
